Patch Guide Adapter - AR-15/AR-10
Description
Bore Tech’s interchangeable AR-15/AR-10 PATCH GUIDE ADAPTERS allow for quick and cost effective rifle model/caliber changes with our Patch Guide System.
Interchangeable Front Adapter Only, Not A Complete Patch Guide Assembly.
Bore Tech’s interchangeable AR-15/AR-10 PATCH GUIDE ADAPTERS are machined from a rugged, solvent resistant, synthetic polymer and allow for quick and cost effective rifle model/caliber changes. Simply loosen the set screw located under the patch plate and swap the adapter.
Interchangeable Front Adapter Only, Not Complete Patch Guide. Complete AR-15/AR-10 PATCH GUIDES and are found on the AR-15/AR-10 Patch Guide product page.
If you don’t see a Patch Guide Adapter that will fit your specific rifle, please contact Customer Service to inquire about our custom order Patch Guide Adapters.
Why settle for anything less than perfection? Choose the best… Choose the Bore Tech AR-15/AR-10 Patch Guide Adapter.
Bore Tech - Redefining Gun Care
Proudly made in the USA
AR-15 Patch Guide Adapter Length: 8.5 Inches
AR-10 Patch Guide Adapter Length: 12.5 Inches
Bore Tech AR-15/AR-10 Patch Guide Adapter Use Instructions
To Change Adapter
1) Locate hex drive set screw under angled patch plate.
2) Using a 1/8” hex key loosen the set screw.
3) Remove adapter.
4) Insert new adapter. On certain rifles adapters must be rotated to the correct position so the angled patch plate faces directly up.
5) Tighten set screw.
Q: Do the Patch Guide Adapters come with the angled patch plate?
A: No, the front adapters do not include the rear angled patch plate assembly. For the complete Patch Guide you must visit the Patch Guide product page.
Q: Can I get replacement O-rings?
A: Yes, please contact a Customer Service Representative so we can be sure to provide you with the correct O-Rings for your AR Patch Guide.
Your Bore Stix and bore guides are top of the line. I have never seen one of better quality.