Nylon Chamber Brush
Bore Tech’s Proof-Positive Nylon Chamber Brushes were specifically designed to effectively remove the stubborn carbon fouling found in AR-15/AR-10 chambers and barrel extensions.
With twice the amount of oversized bristles, double wound cores, looped ends and barrel safe studs these brushes are exceptionally ridged and provide safe and effective scrubbing action.
Bore Tech’s Proof-Positive Nylon Chamber Brushes are 100% chamber safe and set the benchmark for all other nylon chamber brushes. This is due to the superior construction and engineered features that are incorporated into each and every brush.
Unlike phosphor bronze bristled brushes, our premium Proof-Positive Nylon Chamber Brushes are strongly recommend when using fast acting copper removing cleaners such as our Eliminator Bore Cleaner or Cu+2 Copper Remover. These brushes are not affected by copper removing cleaners and will eliminate blue patches and the false indication of copper fouling that is associated with traditional phosphor bronze brushes.
TRADITIONAL BRASS PRODUCTS PROOF-POSITIVE PRODUCTS
All Proof-Positive Nylon Chamber Brushes have twice the amount of extra ridged nylon bristles and each caliber has specifically tailored bristle diameters resulting in double the scrubbing action and faster cleaning.
Each non brass, double wound brush core has a looped end eliminating the sharp cut ends found on many other low quality brushes. This attention to detail along with aircraft grade aluminum studs are all necessary to produce an effective, long lasting, high quality nylon chamber brush for your rifle.
Bore Tech’s Proof-Positive Nylon Chamber Brushes are available in Single Packs for both the .223/5.56mm AR-15 and .308/7.62mm AR-10.
Bore Tech - Redefining Gun Care
Proudly made in the USA
Proof-Positive Nylon Chamber Brushes
|Rifle Brushes||AR-15, AR-10|
|Brush Threads||Male 8/32|
|Brush Length||3.0 inches|
|Core Material||Looped End, Double Wound Alloy|
|Stud Material||Aircraft Grade Aluminum|
Proof-Positive Nylon Rifle Chamber Brushes Use Instructions
1. Screw brush onto Rod
2. Wet brush with cleaner. (Preferably C4 Carbon Remover or Eliminator Bore Cleaner)
3. Insert into chamber and rotate 6 to 12 revolutions
4. Reapply cleaning solvent and continue to brush as necessary
5. Wipe chamber clean with patch or mop
6. When finished, clean brushes before storage.
Q: What do I clean my brushes with after use?
A: When using Bore Tech Cleaners, simply use warm water. We recommend rubbing the brushes between your palms while warm tap water flows over them.
Q: Why do my patches always turn blue when using your brushes with Eliminator Bore Cleaner?
A: Eliminator or any other cleaner that is designed to remove copper fouling will attack all bronze brushes and remove the copper within the bristles. To avoid this false indication of copper fouling in the bore, we recommend using our Proof-Positive Nylon Brushes with all copper removing cleaners.
Q: Will the core of the brush harm my barrel?
A: With our properly designed brushes and when used in a proper manner our brushes are 100% barrel safe.
Q: What thread sizes are your brushes and are they male or female ended?
A: All Bore Tech brushes are male ended and have the thread pitch listed under the Specifications Tab on the respective product page.
These brushes work very well!
Cleans without causing false copper indications. Appears to last longer than most. No negatives noted.
I like nylon brushes over bronze, how much any brush helps with black powder is debatable but I use them and don't like metal brushes in my bores. These seem well made and do the job well.