Patch Guide Adapter - Bolt Action Rimfire

Part# Patch Guide Adapter - Bolt Action Rimfire
  5 of 5 stars (1 Reviews)
Patch Guide Adapter - Bolt Action Rimfire

Description

Bore Tech’s interchangeable RIMFIRE PATCH GUIDE ADAPTERS allow for quick and cost effective rifle model/caliber changes with our Patch Guide System.
Interchangeable Front Adapter Only, Not A Complete Patch Guide Assembly.

$32.99
In Stock! Item Will Ship In 4-6 Business Days
Share

Bore Tech’s interchangeable RIMFIRE PATCH GUIDE ADAPTERS are machined from a rugged, solvent resistant, synthetic polymer and allow for quick and cost effective rifle model/caliber changes. Simply loosen the set screw located under the patch plate and swap the adapter.

Interchangeable Front Adapter Only, Not Complete Patch Guide. Complete RIMFIRE PATCH GUIDES and are found on the Bolt Action Rimfire Patch Guide product page.

If you don’t see a Patch Guide Adapter that will fit your specific rifle, please contact Customer Service to inquire about our custom order Patch Guide Adapters.

Why settle for anything less than perfection? Choose the best… Choose the Bore Tech Rimfire Patch Guide Adapter.

Bore Tech - Redefining Gun Care
Proudly made in the USA

Rimfire Patch Guide Adapter

Bolt Action Rimfire Patch Guide Adapter Length: 8.0 Inches

Bore Tech Bolt Action Rimfire Patch Guide Adapter Use Instructions

To Change Adapter

1) Locate hex drive set screw under angled patch plate.

2) Using an 1/8” hex key loosen the set screw.

3) Remove adapter.

4) Insert new adapter. On certain rifles adapters must be rotated to the correct position so the angled patch plate faces directly up.

5) Tighten set screw.

Q: Do the Patch Guide Adapters come with the angled patch plate?

A: No, the front adapters do not include the rear angled patch plate assembly. For the complete Patch Guide you must visit the Patch Guide product page.

Q: Do the Rimfire Patch Guide Adapters seal inside the chamber?

A: No, due to the wall thickness determined by the case it is not feasible to machine an extremely thin wall. This thin of a guide would become damaged and break.

Q: Do the Rimfire Patch Guide Adapters come with O-rings?

A: No, it is not possible to machine a groove for an O-ring into Rimfire guides due to wall thickness restrictions determined by the case.

 

Rate This Product:

Please log in if you would like to place a review.

I have never seen a cleaning rod of better quality 5 of 5 stars

Your Bore Stix and bore guides are top of the line. I have never seen one of better quality.

By: Francis H. SD, United States August 05,2013